Injection Molding Machine Chapter 4
V3.0
4-61
6 Machine shutdown procedures
Machine shutdown procedures are as follows
：
Ａ
) Switch hoppers baffle plate to close position.
Ｂ
) Press semi-auto key .
Ｃ
) Wait until completion of mold opening
，
take out the product
，
press manual key .
Ｄ
) Press clamp close key and hold until mold halves just contact
，
be sure not to let the mold under
locked position.
Ｅ
) Press carriage retract key to retreat the carriage to retract nozzle away from the mold.
Ｆ
) Press charge key
，
machine starts charging continuously until screw retracted to set position.
Ｇ
) Press injection key to purge out residual material from barrel.
Ｈ
) Repeat procedures F
，
G
，
until charge operation can not retract screw to set position
，
then press
charge key
，
machine stops charge operation.
Ｉ
)Turn off the heater and motor.
Ｊ
) Turn off the main power of the machine.
Ｋ
) Press front and rear emergency push buttons of the machine.
WARNING
Before turning off the motor
，
please confirm that the mold is not in locked position.
To Next Page
Loading...