Injection Molding Machine Appendix D
D-10 V1.0
(10) MEMO COPY TO OUTSIDE: copy mold data stored in USB disk to machine
internal memory.
This function will overwrite existed mold data in USB disk.
Steps: press F2 [ITEM CHANGE] UNTIL [(10)MEMO COPY TO OUTSIDE ] is showed,
Æ use F3,F4, ↑,↓ then enter to select mold file, selected files are colored
in purple, repeat above steps to choose multiple files.
Press F5 will move cursor to INSIDE MEMORY NAME area, enter to selected
source file position, and repeat selection by using move/enter keys.
Press F6 to start copying processes, if there is any mold file has the
same file name as in source file, system will automatically add –1,-2 ,-3…
to the filename.
Wait until system messages show.
COPY OK.
To Next Page
Loading...