Injection Molding Machine Chapter 3
V3.0
3-0
Chapter 3: Preparation for installation
and test running
1. Placing of the machine........................ 3-1
2. Foundation of the machine ................. 3-1
3. Transportation 3-2
3.1 Transportation preparation............ 3-2
3.2 Process of transportation.............. 3-2
4. Leveling…………………………………. 3-6
5. Adjusting of mounting pad…………….. 3-7
6.Ventilation……………………………….. 3-8
7. Preparation before operation 3-9
7.1 Power supply............................... . 3-9
7.2 Cooling water................................ 3-10
7.3 Main power/water connection
position……………………………...
3-10
7.4 Material……………………………... 3-10
7.5 Hydraulic oil，lubrication oil and
grease ..........................................
3-11
7.6 Operating temperature and
humidity ……………………………
3-11
8. Pre-operation checkpoints ……….…... 3-12
8.1 Check before power ON............... 3-12
8.2 Check before motor starting ......... 3-12
8.3 Motor starting inspection............... 3-12
8.4 Check the mold condition ............. 3-14
To Next Page
Loading...