TMC 30E - Page 29

Injection Molding Machine Chapter 3
V3.0
3-3
e. U-bolt
：
JIS F3022
，
65-3(used in 30E~250E).
f. Eye-bolt
：
JIS B1168
，
M16(used in 30E~150E)
3.2.2 Machine lift support position
a. 30E~250E
Method 1:
1
Wire rope
2
Eye-bolt
3
H-beam
，
machine frame.
4
U-bolt on machine H beam
5
Steel pipe, D=76.3mm, t=7mm,be used to lift at both side.
6
Shackle, JIS B2801, SD-12.
Method 2:
Put skates beneath machine bottom, use 10 tons forklift to push it.