Injection Molding Machine Chapter 3
V3.0
3-2
It’s not necessary to prepare a fixed foundation for the machine, using machine mounting
pads with good leveling (0.2mm/M) is usually enough, in case fixed foundation is needed, call
TMC or agent to get all necessary information.
3 Transportation
3.1 Transportation preparation
a. Secure safety gates and hopper cover firmly by rope.
b. Choose appropriate transport vehicle or container according to machine dimensions and
weights.
E-series Weight (kg) Dimension L*W*H mm
30 1500 2500*1000*1500
60 3100 3900*1150*1850
90 3800 4100*1250*1900
120 5200 4400*1300*1950
150 5800 4600*1350*2000
200 8000 5500*1400*2200
250 10000 5850*1500*2250
350 16000 7400*1800*2400
500 25000 8700*2000*2550
750 40000 10700*2150*2850
1000 60000 12000*2450*3050
3.2 Process of transportation
3.2.1 Lift tools
a. Movable crane
：
10 tons
，
20 tons.
b. Lift car
：
5 tons
，
10 tons.
c. Wire rope
：
JIS G3525
，
type 3
，
6*19 G
，
D=18mm.
d. Steel pipe
：
JIS G3459
，
D=76.3mm
，
t=7.0mm and D=60.5mm
，
t=5.5mm. Length of pipe
must be 200mm longer than machine width.
To Next Page
Loading...