TMC 30E User Manual

Injection Molding Machine Chapter 0
0-2
V3.0
5. Adjusting of mounting pad………………………..………………………………………….. 3-7
6.Ventilation……………………………………..……………………………………………….. 3-8
7. Preparation before operation………………………………………………………………….. 3-9
7.1 Power supply....................................................................................................................... 3-9
7.2 Cooling water...................................................................................................................... 3-10
7.3 Main power/water connection position............................................................................... 3-10
7.4 Material ............................................................................................................................... 3-10
7.5 Hydraulic oil, lubrication oil and grease............................................................................. 3-11
7.6 Operating temperature and humidity .................................................................................. 3-11
8. Pre-operation checkpoints…………………………………………………………………….. 3-12
4.1 Check before power ON...................................................................................................... 3-12
4.2 Check before motor starting................................................................................................ 3-12
4.3 Motor starting inspection .................................................................................................... 3-12
4.4 Check the mold condition ................................................................................................... 3-14
Chapter 4: Operation
1. Operation panel………………………………………………………………………………... 4-1
1.1 Screen /function selection key............................................................................................
4-1
1.2 Number/alphabet key..........................................................................................................
4-1
1.3 Direction/screen operation instruction key.........................................................................
4-1
1.4 Manual operation switch.....................................................................................................4-1
2. Screen layout and operation…………………………………………………………………… 4-3
2.0 Main page of operation screen............................................................................................
4-5
2.1 Main page of operation screen............................................................................................
4-7
2.2 Machine monitoring screen ................................................................................................
4-8
2.3 Clamp open/close setting....................................................................................................
4-9
2.4 Clamping parameters..........................................................................................................
4-11
2.5 Ejector setting.....................................................................................................................
4-13
2.6 Ejector parameter................................................................................................................
4-15
2.7 Corepull setting...................................................................................................................
4-17
2.8 Corepull parameters............................................................................................................
4-19
2.9 Injection setting ..................................................................................................................
4-20
2.10 Injection parameters...........................................................................................................
4-22
2.11 Injection closed loop control ..............................................................................................
4-24
2.12 Charge/Carriage setting .....................................................................................................
4-26
2.13 Charge/Carriage parameters ..............................................................................................
4-28
2.14 Temperature setting ...........................................................................................................
4-30
2.15 Temperature parameters ....................................................................................................
4-31
2.16 Molding data store…….………………………………………………………………...
4-33
2.17 SPC data ………………………………………………………………………………….
4-34

TMC 30E Specifications

General

Brand	TMC
Model	30E
Category	Industrial Equipment
Language	English