Injection Molding Machine Chapter 0
0-5
V3.0
1.2 Adjustment of moving platen shoes.................................................................................... 7-2
2. System adjustments.................................................................................................................... 7-3
2.1 Adjustment of transducer…………………………………………………………………. 7-3
2.2 Adjustment of proportional valve………………………………………………………… 7-5
2.3 Adjustment of motor overload protector…………………………………………………. 7-6
Appendix A
1 Hydraulic sequence ………………………………………………………… A-1
2 How to re-open clamp when it locked …………………………………………………. A-17
Appendix B
Notes on motion/no motion…………………. ……………………………………………… B-1
Appendix C: Robot Connection………………………………………………………………….. C-0
Appendix D: USB file operation…………………………………………..…………………….. D-0
Chapter 8：Drawings
1. Description of major component parts and their positions installed on the machine
1.1 View from operational side
1.2 View from rear operation side
2. Appearance dimension drawing
3. Screw/Barrel unit assembling drawing
4. Hydraulic circuit drawing
5. Hydraulic manifold drawing
5.1 Injection manifold
5.2 Clamp manifold
5.3 Ejector manifold
6. Oil pipes layout drawing
7. Electrical wiring diagram
8. Control box layout drawing
To Next Page
Loading...