Injection Molding Machine Chapter 4
V3.0
4-22
2.10 Injection parameters
On INJECTION screen press F2 INJ. PARAMETER.，or use the direction key in the main
menu screen to move the cursor to INJECTION PAR.，press ENTER to display this screen.
10h25m10s
20°C
GAS VENT DELAY T.
HOLD PRESS SLOPE
OFF NOZZLE DELAY T.
MOLD OPEN PT.
F2F1 P/V
MENU
23
RAMP
GAS VENT T.
GAS VENT COUNT
E5
E4
GAS VENT
GAS VENT PT.
INTRUSION T.
E2
E3
E1
E
D
INTRUSION
SHUT OFF NOZZLE
C
B
CUSHION MONITOR
INJECTION SLOPE
A
3W
SUPPORT
INJ. HOLD PRESS
MOLDF3 F4AUTO INJ.
PURGE PROFILE
< 4>
< 2.0>
00
0.0
F5 F6CHANGE
LOG
INJ. SPEED
I
H
MANAG.
SECTION
SECTION
PROD.F7 F8
FUNCTION
< 4 >
< 3 >
100.0mm
100.0mm
HOLD PRESS VOL.5~10%
PRESET SUCK BACK
PRESET CUSHION
PARAMETER AUTO SET
GAS ASSIST INJ.
GAS ASSIST SIGNAL
GAS ON DELAY T.
OFF
< 0.0>
< 20.0>
< 40.0>
OFF
< 5.0>
0.0
0.0
< 0.0>
OFF
OFF
0.0
G4
G
G6
G5
SCREW DIA.
RESIN DENSITY
UNIT WEIGHT
GAS ON T.
G2
G3
G1
ACTION STATUS
OFF
OFF
M:
F
1.0mm
210.0mm
< 0.00 >mm
< 00 >
OFF
< 45 >mm
< 12.0>mm
< 1.00 >
< 60>g
<10.0>
0.0
0/ 0
0/ 0 0/ 0
OFF
<100.0>
<10.0>
P1:
mm
0.0
P2:
0/ 0V1: V2:03D05M07Y
Screen 4-13
Ａ CUSHION MONITOR
： When set on，injection end position must be in between low and
high limit position，if not，alarm will be fired and bad parts counter is increased by one set.
Ｂ SHUT OFF NOZZLE：Option device
，
if purchased
，
set it on.
Ｃ INTRUSION：If the injection volume is still insufficient even at the maximum charge
stroke，for some plastic material of low viscosity，such as PP，PE，PU，charging can be
performed to intrude some plastic material into mold cavity before the injection is
performed.
The first charge section setting is used to run intrusion.
Ｄ INTRUSION T.：Charge running time for intrusion.
Ｅ GAS VENT：When set on，run gas vent sequences as below.
To Next Page
Loading...