Injection Molding Machine Chapter 4
V3.0
4-23
GAS VENT
COOLING
CHARGE
HOLDING END
MOLD CLOSE
INJECTION
E2
DELAY
END
E1
SEQUENCE
END
MOLD OPEN
NORMAL
INJECTION
COUNT E5
E4
E3
END
MOLD OPEN
TIME
MOLD CLOSE
Ｆ GAS ASSIST INJ.：Set on to run gas assist injection sequences.
HOLDING INJECTION
GAS ASSIST SIGNAL mm
GAS ON DELAY T.
GAS ON T.
I/O 54
ON
Ｇ PARAMETER AUTO SET function：key in A SCREW DIA. and some other data of
G1~G6，then move cursor to PARAMETER AUTO SET and set on，computer will
automatically set charge end position CH. END and P/V TRANS. POINT.
Ｈ INJ. SPEED < > SECTION
：set desired steps for injection phase.
Ｉ INJ. HOLD PRESS < > SECTION：set desired steps for holding phase.
To Next Page
Loading...