Injection Molding Machine Chapter 4
V3.0
4-31
2.15 Temperature parameters
On TEMPERATURE screen press F2 TEMP PARAMETER or use the direction key to move
the cursor to TEMPERATURE PAR.
，
press ENTER to display this screen.
10h25m10s
20°C
INJ. WITH TEMP KEEP
SUN
EARLY HEATING TEMP KEEP START AT THE SAME TIME
03D05M07Y
F2F1
MENU
01
TEMP PID
NOZZLE TEMP KEEP
B
C
START T.
STOP T.
0: 0
0: 0
WEEK
A
ALARM OFF HEATER
3W
ALARMF3 F4 INJ.
PROFILE
F5 F6CHANGE
LOG LOG
TEMP
KEEP
F7 F8DIAGNO
-STIC
100.0mm
50.0mm
SAT
OFF
WED
0: 0
0: 0 0: 0
0: 0
0: 0
0: 0
MON TUE
0: 0
0: 0 0: 0
0: 0
0: 0
0: 0
THE FRI
COOL FAN ON
TEMP.OVER COOL+
ACTION STATUS
OFF
OFF
M:
F
E
1.0mm
OFF
5
D
110.0mm
0/ 0
0/ 0 0/ 0P1: P2:
0/ 0V1: V2:
OFF
COLD START T. SKIP
SET 00:00 TO CANCEL
Screen 4-18
Ａ ALARM OFF HEATER
：If this function is on in auto mode，when the machine stop
because of alarm. Unless the alarm is resolved，the heater will be shut off when
unattended time is up
Ｂ NOZZLE TEMP KEEP：When set on，temperature setting unit in H1 is changed to %，
100 or greater means H1 is always on，20 means heater is on for 20% heating cycle，
heater is off for 80% heating cycle.
Ｃ ON T./ OFF T.：Heater automatic start and stop time setting，set 0：0 to disable early
heating function.
Ｄ COLD START T. SKIP
：When set on，the cold start protection timer only activate one
time after machine power up.
Remarks: Only the COLD START T. SKIP
in machine parameter setting 2 is set on
，
then
this function is allowed to set on.
Ｅ COOL FAN ON.：For those machine equipped with optional barrel cooling fans，when set
on at heater off status，cooling fans will energized all the time.
Ｆ TEMP.OVER COOL+：When actual temperature is higher than this setting，cooling fan
To Next Page
Loading...