Injection Molding Machine Chapter 4
V3.0
4-55
3 Machine operation procedures
COOLING
MOLD OPEN
END
EJECTOR
RETRACT
CORE OUTCORE OUT
OPEN
MOLD
CORE OUT
CYCLE START
CYCLE END
CLOSE GATE
ROBOT
PRE-SUCK
INTRUSION
RETRACT
CARRIAGE
BACK
SUCK
BACK
CHARGE
CARRIAGE
INJECTION
HOLDING
ADVANCE
EJECTOR RET.
CORE IN
CORE IN
LOCKED
MOLD
CLOSE
CORE IN
MOLD
Screen 4-38
4 Start up
Check all safety related items are ok according to maintenance screen (P1-1)
，
then release emergency
push buttons
，
turn on main power
，
turn on heater power
，
turn on pump motor power
，
wait until
temperature conditions are OK.
4.1 Manual operation
→
Clamp close
→
Carriage
Advance.
→
Injection
→
Charge
→
Suck back
→
Carriage
Retract
→
Clamp open
→
Ejector adv.
→
Ejector ret.
Ａ
) Press manual key to switch to manual mode
，
close all safety guards/doors.
Ｂ
) Press manual clamp close key until clamp close is completed.
Ｃ
) Press manual carriage advance key to perform carriage advance operation.
To Next Page
Loading...