Need help?Do you have a question about the TMC Pro Pond ro Pond UV110 and is the answer not in the manual?
Always isolate the unit from mains electricity before carrying out any maintenance.
Dispose of this unit responsibly via authorized collection points for environmental safety.
Appliance use restricted for persons with reduced physical or mental capabilities.
Damaged supply cord must be replaced by qualified personnel to avoid hazard.
Always consult a qualified electrician for installation and electrical work.
Avoid direct eye exposure to the illuminated UV lamp to prevent damage.
Do not operate the unit without water, as it can cause damage.
Ensure power supply uses an RCD with a rated residual operating current not exceeding 30mA.
Ensure the unit is properly earthed for electrical safety.
The unit is weatherproof but not waterproof; do not submerge.
Immediately replace the quartz sleeve if it is cracked to maintain function.
Ensure young children are supervised when near water sources.
Protect the unit from frost or store indoors during winter months.
Unit manufactured and conforms to relevant BS EN and EN safety and EMC standards.
The unit has undergone assessment and meets EU requirements for safety and health.
Caution against installing unit above or alongside the pond to prevent it falling in.
Unit can be mounted on flat or vertical surfaces; secure positioning is recommended.
Unit can be mounted on any suitable flat surface, including filter lids.
Unit can be mounted on walls using the provided kit, ensuring secure fixing.
Unit has stepped ports for 2" or 63mm BSP plastic pipe or flexible plumbing.
Recommend passing pond volume through UV unit once every two hours for optimal performance.
Consult electrician; use RCD; ensure proper earthing; use correct fuse.
Unit designed for permanent wiring via 3-core cable, weatherproof enclosure, and fused spur.
Replace the 3.15 Amp quick blow fuse with the same type only after isolating the unit.
UV lamps have 8000 hours life; replace annually in spring.
Remove lampholder restraint screws for maintenance, then reattach securely.
Clean quartz sleeves periodically to ensure UV light penetration.
Slide the clean, dry quartz sleeve into the unit, ensuring 'O' rings are correctly placed.
Plastic body and fittings may erode from UVC and water; inspect regularly.
The 24-month guarantee does not cover serviceable parts like the lamp and quartz sleeve.
General| Brand | TMC |
|---|---|
| Model | Pro Pond ro Pond UV110 |
| Category | Lighting Equipment |
| Language | English |
To Next Page