5
INSTRUCTIONS FOR INSTALLATION AND USE
Important Safety Information - Please Read Carefully
• Caution: Do not use any power supply other than the one supplied with your genuine
Reef Flow 2.0 nano pump.
• The use of a different power supply will invalidate the guarantee.
• Always isolate the PSU from the mains electricity before installing or carrying out any
maintenance to the pump. Caution: Reef Flow 2.0 nano controller is not waterproof and
therefore must not be mounted above the aquarium or sump, or in any position where
it may accidentally fall into water or be splashed by water, or in a humid environment.
• Only use the correctly-rated controller supplied with the pump, e.g the Reef Flow 2.0
1000nano Controller with the Reef Flow 2.0 1000nano pump.
• A label on the back of the controller denotes which pump it is designed for. Using the
wrong controller with the wrong pump will invalidate the guarantee.
• Power to the pump must be supplied through a Residual Current Device (RCD) with a
rated residual operating current not exceeding 30mA.
• Never operate the pump without water inside the impeller chamber or with liquids at a
temperature higher than 95F/35C.
• To ensure the pump continues to maintain a steady water flow, it must be cleaned
regularly to ensure it does not become clogged with debris or detritus.
• Do not operate any appliance if it has a damaged cord or plug, if it is malfunctioning, or if
it has been dropped or damaged in any way.
• This unit is designed to be used indoors and is not suitable for any outdoor applications.
• Ensure the Reef Flow 2.0 nano pump is securely installed before operating.
• Always leave a drip-loop in the pump cable to prevent water running down the cable and
reaching the controller and power source (see diagram below).
5
DISPOSE OF THIS UNIT RESPONSIBLY
Check with your local authority for disposal information.
To Next Page
Loading...
Need help?
General
