TMEC 200-1 - STARTING THE ENGINE

11.check
fasten
of bolt and
nut: check
astern of bolt and nut
for
front
and rear wheel
axle
,
check
other
bolt
and nut.
START ENCINE
Slarr engine
as
follows:
.
The vehicle
can
not be stafied
when
the side stand remain
stands
on the ground.
The exhaust gas
contain
poisonous
carbon
monoxide. so, do
not run
vehicle
when the garage
is
closed.
Do not use
electrical
start exceed
5s in one time,
loose the start
button,
and
repress it in
10s.
'
Prepare
Insert
the key
before start,
open the
ignition lock and confirm:
Engine
is in
neutral
position
Flameout
switch
is in
position.
Oil
switch open
Start
process:
, Normal
temperature:
10-35"C
(50-95F)
l.wrest clutch
lever to
total open position.
2.revolve
throttle
I/8
-
114, press
start button,
start engine.
'
3.press
clutch lever
to center position.
4.heat
engine in advance.
5.press clutch
lever to
total close position
after
start engine for
half
mins.
If
neutral revolve
is not
stability,
open throttle little.
15