Why won't my TNT Rescue Cutter engine start?
Several factors can prevent the engine from starting. First, ensure the switch is in the 'on' position. Second, the control valve should be in the neutral position. Third, check the engine oil level and add oil if necessary. Fourth, adjust the choke as per the engine operation manual. Finally, verify that the power unit has sufficient fuel and add fuel if needed.
What to do if TNT Rescue Cutter tool doesn't react when turning the valve?
If the tool isn't responding to valve adjustments, consider these possibilities. First, ensure the power unit is engaged and running. Second, verify that the tool is properly connected via the couplers. Lastly, check the hydraulic fluid level in the power unit and replenish to the correct level if it's low.
Why won't the recoil pull on my TNT Rescue SLC-24 Cutter?
If the recoil won't pull, it could be due to the power unit being engaged. Return the control valve to the neutral position. If this doesn't resolve the issue, contact your authorized TNT Service Representative.
Instructions for connecting and disconnecting standard 10,500 PSI hydraulic couplers.
Instructions for connecting and disconnecting flat face 10,500 PSI hydraulic couplers.
Instructions for connecting and disconnecting COAX 10,500 PSI hydraulic couplers.
Instructions for connecting and disconnecting Nexus 5,500 and 10,500 PSI hydraulic couplers.
Daily checks for tools and components, fluid levels, and basic operation.
Weekly checks including blade and yoke area inspection, fluid levels, and operation.
Monthly checks covering tools, components, fluids, operation, fuel, and air filter.
General| Brand | TNT Rescue |
|---|---|
| Model | SLC-24 |
| Category | Cutter |
| Language | English |
To Next Page