Tobe S230 - Arming and Disarming the Car Alarm; Arming Process and Function Test; Disarming Process and Notes; Switching Off Siren by Emergency Key

To Previous Page

..USER MANUALUSER MANUAL..

ARMING THE CAR ALARM

Close the car's central locking by its remote control.

The car alarm confirms by flashing LED (and by 3 beeps) to have been activated now.

After a inhibition time of 30 seconds the car alarm is armed.

FUNCTION TEST: During this inhibition time each surveillance sensor can be tested, since its

triggering (for example by opening door or bonnet) will be indicated by a beep.

IMPORTANT: It is not possible to arm the system, as long as the blinker (for example the

parking light function or emergency hazard) is switched on.

DISARMING THE CAR ALARM:

Open the car's central locking by its remote control.

The car alarm confirms by switching off its LED (and by 1 beep) to have been deactivated and

disarmed.

NOTE: Alarm-memory: In case the alarm has been triggered in an armed period (and not been

switched off by emergency key), this will be indicated now by a quicker 4 beep sequence

NOTE: A delay of 2 - 3 seconds between arming and disarming operations is advisable.

NOTE: In any case of emergency the car alarm can be disarmed by emergency key.

SWITCHING OFF THE SIREN-ALARM BY EMERGENCY KEY

In case alarm is triggered and siren is still signalling alarm, this siren sound can be switched off

only by switching OFF the car alarm by emergency key.

In order to disarm now the car alarm definitively, after switching it ON again by emergency key,

now open the car's central locking by its remote control.

Exclusion of beep signals: Reactivation of beep signals:

1. Switch OFF the car alarm by emergency key 1.Switch OFF the car alarm by emergency key

2. Switch ON ignition (+15) 2.Switch ON ignition (+15)

3. Switch ON the car alarm: 1 beep confirms 3.Switch ON the car alarm: 1 beep confirms

4. Switch OFF the car alarm: 1 beep confirms 4.Switch OFF the car alarm: 1 beep confirms

5. Switch ON the car alarm: 1 long beep confirms 5.Switch ON the car alarm: 1 long beep confirms

From now on, the arming and disarming From now on, the arming and disarming

will not be indicated by beep-signal. will be indicated again by beep signals.

installation

date:

by:

TECHNICAL CHARACTERISTICS

activation and inhibition time 30 seconds

alarm duration 30 seconds

alarm cycles 10

recycling time 5 seconds

trigger delay 4 seconds

power consumption disarmed 7 mA

armed 11 mA

alarm triggered:0,8 A

power supply 12 V dc (±1V)