OPERATING PROCEDURE
NOTE:
- The steam brush may give off some smoke when you use it for the first time. The smoke will
disappear after a short time.
- DO NOT touch soleplate or steam it is hot and can burn or scald.
Iron Setting
- Rotate the Temperature Knob (L) clockwise, put the iron on a stable surface.
Filling with water (for steam ironing)
- Please fill this iron with normal tap water before using for the first time.
- For refilling, you can also use tap water. However, if the water is very cloudy, it is advisable to
use distilled water.
- Always remove the plug from the wall socket before filling the iron.
- Open the water inlet. Use the water cup to fill clean tap water into water tank up to MAX level.
Or use the measuring beaker with spout for this purpose.
- Replace water tank cover and dry the spilt water around the enclosure of the appliance. Do not
overfill.
Temperature Setting Guide
NYLON / ACRYLIC / ACETATE
- Use the temperature knob to set the iron temperature to suit the type of material. We
recommend using the above table as a guide. The temperature indicator light indicates that
the soleplate is heating up. When the temperature indicator light goes out, the required
temperature has been reached.
Dry ironing
- Take out the brush
- Rotate the temperature regulating knob to the temperature dial which the clothes require, the
temperature indicator light will illuminate, put the iron on the smooth and stable place.
- After the temperature indicator light turns off, you can begin to ironing.
Strong Steam
- Press the strong steam button, the baseplate will release a strong steam.
- ATTENTION: Only use the strong steam push button when the steam iron has reached the
maximum temperature.
- Do not press this button more than 3 times at once.
To Next Page
Loading...