tomado TLT4702W - Cleaning, Maintenance, and Troubleshooting; Routine Cleaning and Maintenance; Resolving Common Failures

EN - 22
Regularly clean the refrigerator to ensure proper operaon. Before cleaning, switch o the appliance by seng the thermostat
to posion OFF and unplugging the appliance.
Remove the food. Clean the interior of the appliance. Simply remove the shelf to clean them by hand. Use warm water and a
neutral detergent, such as baking soda, to prevent any bad smells occurring. Use two tablespoons and a quart liter of warm
water. Aer cleaning, rinse the interior with clean water and leave the door open to let it air dry for 1 to 2 hours before the
power is turned on. Be careful not to aect the electrical insulaon properes when rinsing with water.
For areas that are dicult to clean in the refrigerator, such as narrow gaps or corners, it is recommended to wipe them
regularly with a so rag, so brush, etc. When necessary use some auxiliary tools, such as thin scks (tooth picks), to ensure no
contaminaon can accumulate in these areas.
Clean the outside of the refrigerator and the door gasket with mild soap and water. Use a so moist cloth.
We recommend that you dust the back of the appliance and on the oor with a cloth or vacuum cleaner once a year in order to
maintain a good output and low energy consumpon.
Do not use hard brushes, cleaning steel wire balls, wire brushes, abrasives, such as toothpastes, organic solvents (such as
alcohol, acetone, oils, etc.), boiling water, acid or alkaline items to clean the refrigerator considering that this may damage the
fridge surface and interior. Boiling water and benzene may deform or damage plasc parts.
Breakdown Cause Solution
The appliance
no longer works
There is an interrupon
in the power supply.
- check that the plug is properly inserted in the socket
- check that the power cable is not damaged
- check that there is voltage on the socket by connecng
a dierent appliance, such as a night lamp
- ensure that the appliance is on by not seng the
thermostat to the OFF posion
Temperature in the
refrigerator is too high or
too low
Wrong seng of the thermostat. - turn the thermostat to a dierent posion
The ambient temperature is higher
or lower than the
temperature indicated in the table
with technical data.
The appliance is intended for operaon in an
ambient temperature indicated in the table with technical
data supplied with the appliance.
The appliance is located in direct
sunlight or near a heat source.
Change the locaon of the appliance according
to the informaon in the instrucon manual.
The venlaon at the rear of the
appliance is hindered.
Keep the appliance 10 cm away from the walls,
for sucient venlaon.
The door of the refrigerator is
opened too frequently or remains
open for too long.
Open the door less oen and/or reduce the me that
the door remains open.
The door is not closed properly. Make sure the foods are placed in such a way that they
do not hinder the door when it is being closed.
The compressor does not work
oen enough.
Check that the ambient temperature is not lower than
the range of the climate class.
The door rubber is loose. Fasten the door rubber or have it replaced.
The appliance is working
connuously.
Wrong seng of the thermostat. - turn the thermostat to a higher posion
There is water
in the lower secon of the
refrigerator.
The opening of the defrost water
drain is clogged.
Clean the opening of the defrost water drain by means
of the skewer.
The venlaon within the
refrigerator secon is hindered.
Check that the food does not make contact with the rear
wall of the refrigerator.

