② Turn ECO-MODE switch to "ON";
③ Insert the plug into
an AC outlet;
④ Make sure that the AC indicator is lit up;
⑤ Switch on the electrical equipment.
Tip: Before increasing engine speed, the ECO-MODE switch must
be switched to "OFF". If the generator set supplies power to multiple
loads or electrical equipment, start from large to small according to the
output of each electrical device.
（3）Generator grounding
In order to prevent any damage to the generator caused by electric shock or
improper electrical application, it is recommended that the generator is
grounded with a good conductor with insulating sheath.
① Please use grounding wire with sufficient electrical energy capacity;
② Connect one end of grounding wire to grounding bolt on control panel of
the generator set;
To Next Page
Loading...
Need help?
General