To Next Page

To Previous Page

6）. Refill oil to a proper level;

7）. Tighten oil dipstick, cover external cover plate and tighten the knob.

（4）Air filter

Dirty air filters may prevent air from flowing into the carburetor. In order to

prevent carburetor failure, replace the air filter regularly. If being used in a

dusty environment, it must be replaced frequently.

1). Unscrew the knob ①, to remove cover plate of the

air filter ②;

2). Remove screws ③, to remove cover plate of air

filter ④;

3). Remove foam filter element ⑤;

4). Clean foam filter element with cleaning

solvent and blow it dry;

5). Drip a few drops of oil on foam filter element and

squeeze off excess oil. The foam filter can be wet,

but there should not be any oil dripping.

ATTENTION

Be sure not to twist the foam

filter

forcibly to avoid damage.

6). Place foam element into air filter;

Tip: Make sure that the surface of foam filter

element is in close contact with the air filter, and

there is no gap. Be sure not to start the engine

before air cleaner is assembled, because it will

generate excessive toxic fumes and wear the

cylinder;

Recommended oil: SAE S10W/30

Oil grade: API Standard Model SJ

or Higher Volume: 12 FL OZ

①

②

⑤

③

④

Tomahawk TG2000i User Manual

Questions and Answers: