If the Seat Cannot be refitted! Two things may be wrong!
• Check the trolley bayonet lock is fully open as shown in Fig 3.
• The seat may not have been central when removed. If so, try to refit the seat in
the orientation it was removed (usually toward the pedestrian side of the vehicle).
The bayonet is designed to only allow the seat to fit in the correct way and will
only allow it to be refitted in the orientation in which it was removed.
• Alternatively, reset the swivel to the central position by rotating the "Bayonet
Plate" (1) until the detent post (2) is mid position as shown in Fig 5. Now fit in
the normal way.
If the seat feels loose or wobbly, do not continue to use the vehicle. Refer to the
maintenance instructions.
| SIL VER BU LLE T & AR ROW
PA GE | 1 5
Fig. 5
8.7 Water-resistant seat cushions.
Seat and backrest cushions are covered in a nylon coated polyurethane material
that is impervious to liquids so liquids falling on the seat will not be absorbed by
the cushion cover or inner foam cushion. If the seat should become wet or need
cleaning, it can be dried with towels and hygienically cleaned with mild household
detergents for almost immediate re-use. However, it should not be pressure
washed, or unnecessarily or continuously exposed to the elements as this may
encourage mould to form between the cushion and back-plate.
1
2
To Next Page
Loading...