Note: If there is no SSID in the scanned list, you can scan it more times. If it does not scan all
the time, please confirm whether the CPE supports the current (frequency) channel of the
WLAN base station or the AP. In addition, check whether the wireless protocol of the CPE and
the AP is a match or not, and if necessary, reset the factory settings before setting the
connection. After restoring the factory settings, the IP address of the CPE is 192.168.0.1,
which is different from the IP address on the label on the back of the CPE.
Technical Support:
A. Thank you for your order and using our product, please read the manual carefully before
use. If there are any problems during the use, please contact us in time;
B. The installation of this device requires some network knowledge. If you can't install it, please
let us know or contact a professional.
Tech Service Email: support@tomlov.com
To Previous Page
Loading...
Need help?
General