1
2
Plug in the unit, the empty tank
warning light will illuminate (L).
An alternative option is to use 1 litre of
clear/ white (food grade) vinegar.
Top up the water tank to the max line
with freshly boiled water and place a
suitable container under the
dispenser spout (C).
Press the cleaning button (O) on
the side of the machine for 2
seconds. The cleaning mode light
will illuminate.
CLEANING
Place a suitably sized container
under the spout (C).
Press the cleaning mode button for
2 seconds to empty the tank.
Remove the old filter and discard
(dispose of the filter in general
household waste).
Follow CLEANING steps followed
by SET UP steps 1-15.
1
2 3 4
REPLACING YOUR FILTER
We recommend that you complete a cleaning cycle, whenever you replace your Tommee Tippee water filter.
Your unit comes with a Tommee Tippee water filter which lasts 150 litres (this is approximately 3 months based on
6 x 260ml feeds per day). Replacement Tommee Tippee water filters are available from all Perfect Prep stockists.
Using this machine without a water filter or with a non Tommee Tippee water filter could put your child’s health at risk.
We recommend you complete a cleaning cycle every 4 weeks, whenever you replace your Tommee Tippee water filter
or if the machine has been unused for a period of 7 days.
TIP: carry out the cleaning process when your tank empty light is illuminated (L) so there’s no need to discard any water.
Once this is done, insert the hopper and follow SET UP steps 1-15 (no need to use step 9a or 12 if re-fitting current
Tommee Tippee filter).
2
4
8
You can re-start the cycle by pressing
the cleaning button again (O). Allow
the cycle to fully complete. Discard the
contents from the container used.
Remove lid, hopper (G) and
bottle stand (F) and set filter
to one side (top side down).
Clean the external machine surface
with a clean cloth (we advise to use
an antibacterial solution), taking care
to clean in all grooves and under the
dispenser spout (C). At this time the
hopper (G), lid and bottle stand (F)
should also be cleaned using hot
soapy water, rinsed thoroughly, and
allowed to dry naturally (do not use
cloths or tea towels to dry).
1
Using a cold water
sterilising solution
(following manufacturer
guidelines for using 1.8 litres of
water) add required amount to the
the water tank.
Fill the water tank to the max line
with cold water and place a
suitable container under the
dispenser spout (C).
TIP: If using a container less than
1.8 litres capacity you can press
the start button (A) to pause the
cleaning cycle, allowing you to
discard of the contents.
3a 3b
5
A solid red light will illuminate as
an early warning, so you can make
sure you have a replacement filter
ready for when it needs changing.
When the red light flashes,
replace the filter.
To Next Page
Loading...
