EN | IMPORTANT WARNINGS!
These instructions can also be found at www.tommeetippee.com
Keep this instruction sheet for future reference as it includes important
information.
Children shall not play with the appliance. This appliance is intended for household
use only. Do not use outdoors. Before plugging in the steriliser for the first time
ensure that the voltage is compatible with your electricity supply by checking
the label on the base of the unit. Ensure water has been added to the unit before
switching the unit on. Do not immerse in water. To protect against fire, electric
shock and injury to persons do not immerse cord, plugs or other parts of the unit
in water or other liquid. Misuse of the product may result in the risk of fire, electric
shock and/or personal injury. Do not put base with plug into the dishwasher. This
appliance shall not be used by children. Keep the appliance and its cord out of
reach of children. This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction
concerning the use of the appliance by a person responsible for their safety.
Children do not understand the dangers associated with operating electrical
appliances. Never allow children to use this appliance. User maintenance other
than cleaning and descaling is not required for this product. Cleaning and user
maintenance shall not be made by children.
The surfaces will get hot during use.
Do not touch hot surfaces, use handles and be careful not to touch the side walls
of the lid. Do not place anything on top of the steriliser. The heating plate surface
is subject to residual heat after use. Allow to cool before cleaning. When in use
the steriliser contains hot water and steam. Keep hands and arms away from
steam vents as it can cause burns and scalds. Use in a well ventilated area. Do
not operate any appliance with a damaged cord or plug or after the appliance
malfunctions or has been damaged in any manner. If the supply cord is damaged
it must be changed by a qualified person in order to avoid a hazard. Always use
on a flat, dry heat resistant kitchen work top surface. Do not move appliance
when in use. Do not let the cord hang over the edge of the kitchen work surface
or touch hot surfaces. The product has been fitted with a cord wind on the base
of the unit to allow you to adjust the length of the cord safely. It is recommended
that the cord be kept as short as possible. Do not use any accessories other than
those supplied with this appliance. The cord must exit the cable tidy using the exit
recess. If the cord is correctly placed in the tidy the product will sit level. Do not
start using the product if it is not sitting level. Regularly check the cord and plug
for signs of damage, if visible remove from use immediately.
SET UP
CLEAN YOUR STERILISER BEFORE FIRST USE - Refer to parts guide and diagram
1. Do not connect to power at this stage.
2. Remove all items from inside the steriliser base.
3. Pour exactly 80ml of water into the steriliser base.
4. Assemble the lower tray (a) with logo front facing and upper tray (a) and place in the steriliser base.
5. Add the lid (g).
6. Plug into the mains supply. Switch on at mains supply.
7. Press the play button and it will light up amber to show the sterilising has begun.
8. The light will switch o when sterilising has finished.
9. Allow to cool for 5 minutes before turning o at the mains, removing the plug and steriliser lid.
10. Remove upper tray and lower tray, pour away any remaining water and wipe dry. Your steriliser is now ready to use.
This steriliser is designed for use with Tommee Tippee bottles and feeding accessories (except bottle brush).
The steriliser will hold a maximum of 6 Tommee Tippee bottles or a combination of fewer bottles plus soothers and breast pump parts.
PARTS GUIDE
CLEANING
Unplug and allow to cool before cleaning. After each use pour away remaining water from the steriliser base by tipping the steriliser sideways over a sink and
wipe clean with a damp cloth only. Do not clean with abrasive cleaners or allow to come into contact with solvents or harsh chemicals, damage could result.
DE-SCALING
The frequency of de-scaling should be as follows:
Hard water: 14 days
Medium: 21
Soft: 28
You can find out your water quality via your water provider. FAQs and a picture of limescale can be found on our website. After each use pour away remaining
water from the unit base by tipping the unit sideways over a sink and wipe with a damp cloth only. Unplug the unit and allow to cool before cleaning. A build
up of limescale can negatively aect the performance of the unit. We recommend carrying out the descaling process as per above frequency guidelines to
ensure the unit continues to work eciently. Living in a hard water area can produce limescale quicker than other areas therefore descaling is required sooner.
Use a descaler that is suitable for use with stainless steel and use as per the manufacturer’s guidelines. Alternatively you can use white vinegar or a descaling
sachet to descale your unit, please use as per manufacturer’s guidelines. Where no method is stated, 1 sachet to 200ml of hot water ratio can be applied. See
our website for detailed descaling method. Once you have descaled then follow instructions under set up to perform a final cleaning cycle. DO NOT use metal
objects or scourers to clean your unit. DO NOT use bleach or sterilising fluid to clean the unit. DO NOT use abrasive or anti-bacterial materials. DO NOT scrub
the heat plate.
TROUBLE SHOOTING
Steriliser will not work
Check the mains lead is plugged into the unit and the mains socket is switched on. Check the fuse is in the plug (in a UK plug only). Check the socket by
plugging in another appliance. Check the appliance by plugging into another socket.
Excessive steam
Check that items are correctly loaded in steriliser. Use exactly 80ml of water.
Bottles come out with a chalky mark
Steriliser needs descaling. Refer to De-scaling Instructions.
Cycle takes too long to complete
Too much water in steriliser. Use exactly 80ml of water.
a. Removeable lower tray
b. Removeable upper tray
c. Drying rack (parts a+b) with sterile surface
d. Locator for Tommee Tippee bottle neck
e. Locator for Tommee Tippee anti-colic valve
(for use if sterilising advanced anti-colic bottle)
f. Locator for bottle hood
g. Lid
h. Steriliser base
i. Lead with plug
j. Power button (play)
k. Stop button
l. Sterilising indicator light
m. Steam vents
n. 80ml measurement on Tommee Tippee bottle
o. Cable tidy
m
g
f
b
e
d
a
i
l
j
k
h
o
c
n
To Next Page
Loading...
