TomTom RDS-TMC User Manual

RDS- TMC Receiver Guide
This guide explains how to install and use the TomTom RDS-TMC
Traffic Receiver.
The RDS-TMC Traffic Receiver
provides the latest traffic reports to
help you improve travel planning and reduce journey times.
You can
either receive traffic information from TomTom Traffic using
a wireless data connection or RDS-TMC information using the RDS-
TMC Traffic Receiver.
You cannot use both services at once.
Note: If radio reception is poor, for example when you are driving
through a mountain valley, RDS-TMC reception will also be affected.
e In
Important: When you install your navigation device in your car, don't
block the driver's view of the road.
1. Connect the RDS-TMC Traffic Receiver to your navigation device.
2. Connect the Car Charger to the RDS-TMC Traffic Receiver and
then plug the Car Charger into your car's cigarette lighter socket.
Note: The RDS-TMC receiver does not work if the Car Charger is not
connected.
3. Place the transparent suction cup at the tip of the antenna firmly
against the upper left of your car windscreen.
(c=J)
(
4. Then place the remaining suction cups along the edge of the
windscreen, as shown, and keep the cable straight.
5. Switch on your navigation device.
The Traffic bar is
shown in the Driving View and your navigation
device searches for a radio station that carries RDS-TMC
information.
4

TomTom RDS-TMC Specifications

General

Brand	TomTom
Model	RDS-TMC
Category	GPS
Language	English