Installing in your car
Your TomTom VIA navigation device has an integrated mount. See the printed installation
instructions included with your product for more information.
1. Make sure that both the suction cup on your mount and your windscreen are clean and dry.
2. Press the suction cup of the mount firmly against the windscreen on an area where the glass is
flat.
Important: Place the mount so that it does not interfere with your view of the road or of any
of the controls in your car.
3. Turn the rubber grip near the base of the mount in a clockwise direction until you feel it lock
into place.
4. Plug the USB car charger into the power supply on your dashboard.
5. Connect the USB cable to the car charger and your TomTom device.
Your navigation device is now installed. The next step is to switch it on and answer a few set-up
questions.
Switching on and off
To switch on your navigation device, press and hold the On/Off button until you see the start-up
screen. The first time you switch on your device, you have to hold the button down for up to 15
seconds.
Setting up
Important: Take care to select the correct language as the language you choose will be used for
all text on the screen.
When you first switch on your device, you have to answer a few questions to set up the device.
Answer the questions by tapping the screen.
GPS reception
When you first start your TomTom VIA navigation device, the device may need a few minutes to
determine your GPS position and show your current position on the map. In future, your position
will be found much faster, usually within a few seconds.
To ensure good GPS reception, you should use your device outdoors and hold your device
upright. Large objects such as tall buildings can sometimes interfere with reception. GPS reception
can also be affected if the device is placed flat on a surface or held flat in your hand.
To Next Page
Loading...
Need help?
General
