EasyManua.ls Logo

ToolPRO 2200W - Page 15

Default Icon
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
15
STORAGE
If the generator is not to be used or is to be stored for
more than one month the following storage procedure
should be carried out. Drain all the fuel from the fuel tank
(refer to page 18) and the carburettor (see below), ensure
that all the fuel has been drained.
Remove the spark plug and pour approximately one
tablespoon full of clean engine oil into the spark plug
hole.
With the ignition turned OFF gently pull on the recoil
starter cord several times. Re-fit the spark plug and
continue to pull the recoil starter cord until the piston is
on the compression stroke (when resistance is felt) then
stop puling.
Store the generator in a dry well ventilated place under a
cover to prevent any dust or debris from accumulating on
the generator.
DRAINING THE CARBURETOR
1. Turn off fuel valve, make sure fuel is drained and the
tank is empty. Residual gasoline left over a long time
will cause difficulty when next starting the engine.
2. Position an approved fuel container under the
carburetor drain screw to catch fuel; loosen the screw,
Pic. 14. Allow fuel to drain completely into container.
3. Retighten drain screw.
4. After draining the fuel tank and carburetor, start the
engine and allow it to run until the unit runs out of fuel.
Consult hazardous waste management guidelines in
your area for the proper way to dispose of fuel.
When preparing the generator for storage, follow the
guidelines below.
Storage Time Prior to Storing
Less than 1 month No special preparation is required
1 to 2 months Empty fuel from fuel tank
Drain fuel from carburetor
2 months to 1 year Empty fuel from fuel tank
Drain fuel from carburetor
Clean fuel sediment cup
1 year or more Empty fuel from fuel tank
Drain fuel from carburetor
Clean fuel sediment cup
Remove spark plug
Put a tablespoon of engine oil into the cylinder through the spark plug hole. Turn the engine
slowly with the pull rope to distribute the oil
Reinstall spark plug
Change engine oil
*Use unleaded fuel stabilisers formulated to extend storage life. For recommendations, contact your nearest authorised service centre.
PIC. 14

Related product manuals