TOOLSTATION HAWKSMOOR 44787

Questions and Answers

K
Katherine KnappAug 7, 2025
Why is my TOOLSTATION Pressure Washer not reaching full power?
- E
  Edward HoweAug 7, 2025
  If your TOOLSTATION Pressure Washer isn't reaching full power, it might be due to several reasons. The extension cord may not be suitable, so use a proper one. The power source, like a generator, might have too low voltage; try connecting to another power source. Blocked air vents can also cause this, so clean them. Check for insufficient water supply, a dirty filter, or a partly blocked hose or nozzle. A leaking pressure hose should be replaced, and if the system isn't airtight, tighten all connections.
E
Emily ValentineAug 12, 2025
How to fix a TOOLSTATION Pressure Washer that does not start?
- S
  smcguireAug 13, 2025
  If your TOOLSTATION Pressure Washer does not start, ensure it is properly connected to the power supply. If the power cord or plug is defective, or there's another electrical defect, have it checked by a specialist electrician. Make sure the trigger lock is deactivated. Also, a clogged nozzle can prevent starting, so clean it.
T
Timothy LozanoAug 18, 2025
What to do if my TOOLSTATION Pressure Washer has no water jet?
- R
  Ronald JacobsAug 18, 2025
  If there's no water jet from your TOOLSTATION Pressure Washer, first, make sure you're pressing the trigger and that the trigger lock is deactivated. Check the water supply to ensure it's sufficient. A dirty filter, blocked hose, or blocked nozzle can also cause this issue, so inspect and clean them as needed.
J
joshuabrooksAug 26, 2025
Why is my TOOLSTATION Pressure Washer not taking in detergent?
- J
  Jennifer PopeAug 26, 2025
  If your TOOLSTATION Pressure Washer isn't taking in detergent, the detergent might be too dense, so dilute it with water. There could also be deposits or restrictions in the detergent circuit; flush it with clean water and eliminate any restrictions. Ensure the variable spray nozzle is set on low pressure.
R
Richard RamirezAug 31, 2025
How to reduce excessive vibration or noise in TOOLSTATION Pressure Washer?
- B
  britterAug 31, 2025
  Excessive vibration or noise in your TOOLSTATION Pressure Washer can be due to a low water inlet volume; increase the water inlet quantity. Also, check if any bolts or nuts are loose and tighten them.