Top Signal Cel-Fi GO G32 User Manual

You can install the Cel-Fi GO G32 system yourself or
you can have it installed by an RV dealer or service center.
Installation requires running a coax cable into your RV
through an available opening or a specially drilled 0.35-inch
(9 mm) entry point. (Speak with a professional if you’re
not sure how to run cable into your rig.)
Installation tip:
We strongly recommend that
you do a “soft installation”
before permanently mounting
the PUCK-1 antenna and
pulling cable.
Drive to an area with weak
cell signal, then lay out and
connect all the components
inside your RV. Power up
the booster and check the
signal you receive from the
inside antenna using the
Cel-Fi WAVE smartphone app.
The app will tell you if the
booster is experiencing any
errors and, if so, how to resolve
them.




TS053021
There are four main components to install:
1. Outside Poynting PUCK-1 antenna with 6.6′ coax cable
Attach the antenna to the roof of your motorhome with the
3M
®
adhesive pad, the pole-mount bracket, the magnetic base, or a spigot.
(See the PUCK-1 user guide for installation instructions.)
We recommend mounting the PUCK-1 antenna at the very front or very back
of your rig and pointing the inside antenna away from the PUCK-1 antenna.
(This prevents signal oscillation and reduced booster output.)
Insert the connector at the end of the cable into a 0.35-inch (9 mm) hole or
other opening and pull the cable into the RV to the booster. Connect the end
of the cable to the ᴅᴏɴᴏʀ port (the cell tower icon) on the booster.
Do not pinch, kink, loop, or coil the cable.

v.20220407
Continued on the back side…
antenna
w/cable
3M
®
foam
adhesive pad
magnetic
base plate
70 mm
spigot
30 mm
spigot
pole
bracket

Top Signal Cel-Fi GO G32 Specifications

General

Brand	Top Signal
Model	Cel-Fi GO G32
Category	Extender
Language	English

Summary

Installation Components

Outside Poynting PUCK-1 Antenna

The Poynting PUCK-1 antenna attaches to the RV roof via adhesive pad, pole-mount, magnetic base, or spigot.

Cel-Fi GO G32 Smart Signal Booster

The booster requires a 120V AC or 12V DC power source for operation, supporting stationary and mobile modes.

Inside Coax Cable

A flexible LMR195 coax cable connects the booster's server port to the panel antenna via an SMA-to-N adapter.

Inside Panel Antenna

The directional panel antenna broadcasts signal in its pointed direction and can be mounted on flat surfaces.

Installation Tips

Soft Installation Recommendation

Perform a 'soft installation' in a weak signal area before permanent mounting to test functionality with the WAVE app.

Stationary vs. Mobile Mode

Switch between Stationary (max gain when parked) and Mobile (dynamic tower search) modes via the Cel-Fi WAVE smartphone app.