Topcom BW-4752 - Using the heating blanket; Technical data; Cleaning

Heating Blanket BW-4752 5
Heating Blanket BW-4752
ENGLISH
The four clasps on the corners can be used to fix the heating blanket tightly to the mattress. This will prevent the blanket
from moving or creasing.
WARNING
• The creased part tends to cause high temperature which is very dangerous.
In order to keep the electric heating blanket flat and clea
n and to reduce abrasion, please cover the blanket with bed
sheet for use. (Don't cover it with blanket or cotton mat, which will prevent the blanket from transmitting heat.)
6 Using the heating blanket
B
A
0
0
• The heating blanket is equipped with a control unit with 3 positions:
– 2 - maximum temperature;
– 1 - minimum temperature;
– 0 - off
• Check that the control unit switch (A) is in p
osition ‘0’ (lowest) before
connecting it to the mains socket.
• The heating blanket plug (C) and mains plug are fixed to the
co
ntrol unit
LIFT
PULL
.
• Connect the heating blanket plug (C) to the heating blanket
co
nnector (D).
• Connect the mains plug to the mains socket (230V AC/50Hz).
WARNING
The mains socket must be close and easy accessible.
• Place the blanket on that part of your body you wish to
heat and select the desired temperature.
• For rapid heating, select level 2, after a few minutes the
heating blanket will already be pleasantly warm.
• After use, disconnect the blanket from the mains socket.
7 Technical data
Dimensions
Weight
Rated voltage
Power consumption
Material
160x140 cm
1,8 kg
Input: AC 230 V / 50 Hz
2 x 60 W
100% polyester
8 Cleaning
40C
• Machine washing of the blanket is possible; however, hand wiping will prolong the life of the blanket.
• To machine wash, remove the control unit and place the blanket in a net bag and seal it
.
• Use a small amount of detergent and set the washing machine to a "Del
icate Wash" with a maximum
temperature of 40°C. When washed, remove the blanket from the net bag and drape it over a clothes line to dry.
• Do not use clothes pegs to secure it.