Topcom Twintalker 7100 - Advanced Features

8
Twintalker 7100 Sport Pack
13.11.2 Sending a call Tone
Press the button briefly. The call tone will be transmitted on the set channel.
13.12 Roger Beep On/Off
After the -button is released, the unit will send out a roger beep to confirm that you have
stopped talking.
To set the Roger Beep.
• Press the - button nine times. ‘rO’ will be displayed.
• Press to enable (ON) or to disable the Roger-Beep (OF).
• Press the PTT - button to confirm your selection and return to the
standby mode.
13.13 Key-Tone On/Off
When a button is pressed, the unit will beep briefly.
To set the key-tone.
• Press ten times. ‘tO’ will be displayed.
• Press to enable (ON) or disable the Key Tones (OF).
• Press the PTT - button to confirm your selection and return to the.
standby mode.
13.14 Dual Channel Monitor function
In stand-by, the PMR is set on one channel with CTCSS/DCS code. The PMR will only receive
signals transmitted on that channel with the CTCSS/DCS code.
Dual Channel Monitor (DCM) allows you to monitor a second channel with CTCSS/DCS code.
When the Dual Channel Monitor function is activated, the PMR will switch sequentially between
the standby channel + CTCSS/DCS code and the Dual Channel + CTCSS/DCS code.
13.15 Button Lock
13.16 Stopwatch function
The Twintalker 7100 has a stopwatch that will count to 59'59''99.
13.17 Display back light
To activate the backlight of the LCD display, press any button except the PTT- button or the
button .
The LCD backlight will light up for 6 seconds.
14 Earpiece connection
The Twintalker 7100 can be used with the included earpiece.
The connector is located on the upper side of the unit .
Insert the earpiece plug into the connector (2,5mm jack).
The small button on the earpiece has the same function as the PTT - button on the unit
When you use the PTT - button from the Earpiece, you must also use the microphone from
the earpiece to talk into
.
• Press the -button eleven times,” DCM OF" will flash
on the display.
• Press the -button or the -button to change the
channel.
• Press the -button to confirm the channel selection
and go to CTCSS selection. (Press the -button
again to go to DCS selection)
• Press the -button or the -button to change the
CTCSS code or DCS code.
• Press the PTT-button to confirm and return to stand-by
mode.
• To disable the function select "OF" when selecting the DCM
channel.
10
PTT
5
11
11
5
9
6
5
5
9
6
11
• Press and hold the -button for three seconds to
activate the Button lock mode. The button lock icon is
displayed on the LCD Screen.
• Press and hold the -button again for three seconds
deactivate button lock
• Press the -button and hold for three seconds , the
stopwatch display will appear.
• Press the -button to start the stopwatch.
• Press the -button to stop the stopwatch.
• Press the -button to reset the stopwatch to zero.
• Press the -button and hold for three seconds to
deactivate the stopwatch.
5
5
The PTT-button , the -button and the -button will still be
functional when the Button Lock is activated.
11
10
4
10
9
9
6
10
11
10
2
11
11
Do not connect other earpieces. This may damage your device.