3
CONNECTOR FOR EXTERNAL POWER SUPPLY
Connecting the connector cable PC-18 (sold separately) to the connector for exter-
nal power supply will enable the use of the LS-B200 from an external power supply.
The LS-B200 will turn on when connection is made to external power supply. The
power switch of the instrument will not function when an external power supply is
used.
When the instrument is operated with the external power supply, the power-save
and the auto-cut off functions will be invalidated.
REGULATIONS
[U.S.A.] FCC Compliance (FCC-Class B)
WARNING:
Changes or modifications to this unit not expressly approved by the party responsi-
ble for compliance could void the user's authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications.
However, there is no guarantee that interference will not occur in a particular instal-
lation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help.
Means of conformity
This transmitter must not be co-located or operated in conjunction with any other
antenna or transmitter.
This equipment complies with FCC radiation exposure limits set forth for an uncon-
trolled environment and meets the FCC radio frequency (RF) Exposure Guidelines.
This equipment has very low levels of RF energy that is deemed to comply without
maximum permissive exposure evaluation (MPE). But it is desirable that it should
be installed and operated keeping the radiator at least
20cm or more away from person's body.
[California, U.S.A.] Proposition65
[California and NY, U.S.A.] Recycling Batteries
[Canada] ICES (ICES-Class B)
This class B digital apparatus meets all requirements of Canadian interference-
Causing Equipment Regulations.
Cet appareil numerique de la class B respecte toutes les exigences du Reglement
sur le materique brouilleur du Canada.
This Class B digital apparatus complies with Canadian ICES-003
Cet appareil numerique de la Class B est conforme a la norme NMB-003 du
Canada.
This equipment complies with IC radiation exposure limits set forth for an uncon-
trolled environment and meets the RSS-102 of the IC radio frequency (RF) Expo-
sure Guidelines. This equipment has very low levels of RF energy that is deemed to
comply without maximum permissive exposure evaluation (MPE).
But it is desirable that it should be installed and operated keeping the radiator at
least 20cm or more away from person's body.
[EU/UK] EMC NOTICE (EMC-Class B)
In industrial locations or in proximity to industrial power installations, this instrument
might be affected by electromagnetic noise. Under such conditions, please test the
instrument performance before use.
This product complies with the electromagnetic environmental testing of industrial
locations.
Declaration of conformity is available depending on your request.
Contact your local dealer.
Manufacturer
Name: TOPCON CORPORATION
Address: 75-1, Hasunuma-cho, Itabashi-ku, Tokyo, 174-8580 JAPAN
Europe Representative and Importer
Name: Topcon Europe Positioning B.V.
Address: Essebaan 11, 2908 LJ Capelle a/d IJssel, The Netherlands
UK Importer
Name: Topcon Positioning (Great Britain) Ltd.
Address: Unit 2 Sandy Hill Park, Sandy Way, Tamworth, Staffordshire B77 4DU
U.K.
[EU] WEEE Directive
[UK] The Waste Electrical and Electronic Equipment Regulations
EXCEPTIONS FROM RESPONSIBILITY
• The manufacturer, or its representatives, assumes no responsibility for any
damage, or loss of profits (change of data, loss of data, loss of profits, an
interruption of business etc.) caused by use of the product or an unusable
product.
• The manufacturer, or its representatives, assumes no responsibility for any
damage, or loss of profits caused by usage different to that explained in this
manual.
• The manufacturer, or its representatives, assumes no responsibility for con-
sequential damage, or loss of profits due to heavy rain, strong wind, high-
temperature and humidity, or storing or use of the product under unusual
conditions.
• Product failures caused by rebuilding are out of warranty.
• Cautions and warnings included in this manual do not cover all the possible
events.
WARNING:
This product can expose you to chemicals including Lead, which
is known to the State of California to cause birth defects or other
reproductive harm.
For more information go to www.P65Warnings.ca.gov.
the environment and human health, which could otherwise be caused by
inappropriate waste handling of this product. For more detailed information
about the take-back and recycling of this product, please contact your
supplier where you purchased the product or consult.
The use of the symbol indicates that this product may not be treated
as household waste. By ensuring this product is disposed of
correctly, you will help prevent potential negative consequences for
To Next Page
Loading...
Need help?
General
