EN
28 29
power it off immediately.
Pull off the adapter on the power socket when charging is
fi nished.
If the product has water condensation inside, please
power it off immediately.
Q: How long it takes to charge?
A: ITC629 should be charged for two hours at least every
three months for longer battery lifespan.
Q: Can this camera work in a total darkness?Will its
performance be affected by environment light?
A: Infrared Thermographic Camera is used for detecting
infrared radiation from object which won't be affected by
the strength of any visible light. It performs in darkness
as well as under sunshine.
Q: Why the temperature I get from the camera is far below the
real data it should be?
FAQ
A: Different material and same material with different
surface may be different in IR emissivity. To adjust the IR
emissivity according to the table in our manual is
important so that you would be able to get the most accurate
temperature results.
Q: Why I can see 2 images not align with each other?
A: When you are in IR-VL mode, the visible light image and
infrared rays image are all on the monitor. You may need to
calibrate the image while the detecting distance is changed.
Please refer to the Image calibration instruction in the manual.
Q: Can this detect electrical power lines or hot water pipe
behind the walls?
A: That's really depends on the scenario. Generally, you can't
detect the object behind a barrel such as a wall that
does not allow infrared rays going through. But in most
of scenario we can indirectly ‘see’ the hot water pipe
behind a wall as it heats up the wall and generate typical
thermal distribution on the surface of a wall.
Q: What is the farthest distance it can detect?
A: The best test distance is 5cm-1000cm which covers most
To Next Page
Loading...