EasyManua.ls Logo

Topens TC102 User Manual

Topens TC102
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
C030504 VER21a
User Manual of the Photocell Beam Sensor
Model: TC102
Specifications:
Technology: Infrared (Photocell)
Receiver range: ≤20m. Range can be reduced to 30% in bad weather conditions,
such as rain, dust etc.
Frequency: 1.92 KHz
Power supply: 12 to 24V DC/AC
Wave length: 940nm
Input: RX 15mA-TX 30mA, Angle: <±10°
Working temperature: -20-+50
Relay output: 1A max 30V
Definition of the terminals:
Wire connection:
Please refer to the user manual of the gate opener for wire connection.
Install the PBS Switch:
Note: Install the PBS Switch over the height of 20cm. Install the receiver not less than
3m away from the emitter. Vertically install the PBS Switch and keep both emitter and
receiver at the same level.
The wires output direction of the PBS Switch must be down so as to avoid water
ingress. . The user is recommended to add a rubber ring between the PBS Switch and
the Mounting Board (not provided).
Question and Answer IconNeed help?

Do you have a question about the Topens TC102 and is the answer not in the manual?

Topens TC102 Specifications

General IconGeneral
ModelTC102
CategoryAccessories
Frequency433.92 MHz
MaterialPlastic
ColorBlack
TypeRemote Control
CompatibilityTopens gate openers
Power SupplyBattery
RangeUp to 30 meters
PIN Length4 Digits
Operating Temperature-20°C to 50°C

Summary

Specifications

Definition of the terminals

Install the PBS Switch

Related product manuals