topmark XAVI - Page 31

31
1
ASSEMBLING
EN
1.First,put negave side
of 1.5V baery into the
baery compartment
with the spring.
2.Then, put the posive side
of 1.5V baeryinto the baery
compartment with the mark +
3. Adjust baery
to at posion.
4. Close baery cover，
lock the screws ghtly.
11. Use a screwdriver to take the screws out of the baery cover, and take the
baery cover out. Put baeries into the baery compartment according to the
correct polarity, then put the baery cover back and fasten it. Use the same way to
take out baery.
2
3