TOPP S200 - Sliding Pulling Arm Installation - Elbow; Elbow Sliding Arm Components; Elbow Sliding Arm Positioning

10
S200
instructions for installation
11
22
33
44
SLIDING PULLING ARM INSTALLATION - ELBOW
xing plate
Door edge
xing plate
Door edge
The automation must be xed on the side of the hinge.
The distance «A» varies according to the type of the Axle exten-
sion used see table.
The automation must be xed on the side of the hinge.
The distance «A» varies according to the type of the Axle exten-
sion used see table.
COMPONENTS
1- Cover, triangular plates
and 6 xing screws
2- Automation S200
3- Fixing plate
4- Automation tting nuts
5- Sliding elbow arm *
6- Axle extension and
corresponding screw (optional) *
* Supplied separately
Automation positioning with left hinge
Attention to the arrow on the xing plate, the door edge
and the axis of rotation of the door
Automation positioning with right hinge
Attention to the arrow on the xing plate, the door edge
and the axis of rotation of the door