Need help?Do you have a question about the TOPP S200 and is the answer not in the manual?
General| Brand | TOPP |
|---|---|
| Model | S200 |
| Category | Door Opening System |
| Language | English |
Specifies the original installation instructions for the S200 automation.
Provides key specifications like dimensions, weight, and power supply.
Details characteristics for different arm assemblies like articulated and sliding.
General advice and liability disclaimers for users and installers.
Crucial safety guidelines for handling and operating the automation.
Defines the duties and liabilities of the installation technician.
Configuration of DIP switches on the electronic board for initial setup.
Guidelines for correctly positioning safety and activation sensors.
Lists all parts required for articulated arm installation.
Instructions for positioning the automation with left and right hinges.
Detailed steps for drilling, fitting plates, automation, and arm assembly.
Procedure for safely removing spring preloading screws.
Lists all parts required for sliding arm installation.
Instructions for positioning the automation with left and right hinges.
Detailed steps for drilling, fitting plates, automation, and guide assembly.
Procedure for safely removing spring preloading screws.
Lists all parts required for elbow sliding arm installation.
Instructions for positioning the automation with left and right hinges.
Detailed steps for drilling, fitting plates, automation, and guide assembly.
Procedure for safely removing spring preloading screws.
Important checks before making electrical connections to the automation.
Guidelines for connecting power supply cables to the board and motor sides.
Diagram illustrating pre-wired connections on the electronic board.
Wiring diagram for connecting IS6 Topp safety sensors.
Wiring diagram for connecting Optex safety sensors.
Wiring diagram for supplementary IS6 Topp safety sensors.
Wiring diagram for supplementary Optex safety sensors.
How to connect activation sensors for door operation.
Instructions for connecting and configuring an electric lock.
Essential checks before initiating the automation setup.
Overview of key parameters to check before self-learning.
Step-by-step guide to perform the self-learning procedure.
How to set up and operate doors with two leaves.
Specific connections and parameter settings for double leaf systems.
Recommended maintenance intervals and tasks.
Procedure for restarting the operator after a power cut.
Information on the braking system and error indicators.
Explains various error codes and their meanings.
How to access and navigate the parameter configuration menu.
Steps to perform the automatic spring load procedure.
Instructions for removing the automation arm.
How to activate servo-assisted functions using buttons and parameters.
Setup for a restroom door with disabled user access control.
Declaration for partly completed machinery according to EC directives.
Declaration of conformity for the final product with EU directives.
To Next Page
