TOPP S200 - Automatic Spring Load; Automatic Load Procedure Steps

27
AUTOMATIC SPRING LOAD
instructions for installation
S200
1Automatic load procedure:
Simultaneously press
ENTER BUTTON - DOWN BUTTON
and “TURN ON”
the automation.
The display shows «REC»
2-Press and hold down
DOWN BUTTON
until the reference F is aligned with
the microswitch
(the plate will rotate clockwise: down-
load)
3-PRESS ENTER BUTTON
The display shows «ROT»
4-Load as indicated:
Press and hold down
DOWN BUTTON for 365 degree
(the plate will rotate clockwise: load)
5-Insert the screw at
the BOARD SIDE GLS
and tighten fully with an
T Allen key
6-Press ENTER
for ADJUSTAMENT
The display shows «END»
7-Insert the screw at
THE MOTOR SIDE (SMS)
and tighten fully with an
T Allen key
Press ENTER
The automation is now FULL
LOADED.Proceed installation
The display shows
TURN ON
Load
Hold down
Hold down
board side screw
motor side screw
Load
365°