Need help?Do you have a question about the TopSolar SOLAR5005022 and is the answer not in the manual?
Manufacturer reserves the right to change the manual and provides no warranty.
Manufacturer not liable for injury or property damage from installation/operation.
Installation must comply with all applicable local, national, and international electrical standards.
Guidelines on preventing shock, using protective gear, and safe handling during installation and operation.
Module performance data measured under STC; nameplate shows main electrical properties.
How to calculate component ratings and determine conductor/fuse size using STC values and correction factors.
Store components in a dry, ventilated environment in original packaging, protected from damage.
Handle components with care, avoid excessive load/twist, do not lift by wires, and carry by two or more people.
Check for transport damage before installation; contact supplier for defective modules.
PV module surface is vulnerable; avoid damage, scratching, disassembly, or modification.
Do not install near flames or combustible objects; avoid water immersion.
Connect components in series for voltage increase, parallel for current increase; follow wiring rules.
Minimize shadows on modules to prevent power loss and component aging from heat.
Verify wiring is correct before system start; check voltage and current against specifications.
Ensure MC4 connectors are tightened, properly connected, kept dry, clean, and not subjected to external pressure.
Semi-flexible components have no exposed conductors; grounding not required by NEC.
If bracket is conductive or requires grounding, ensure system meets local electrical codes.
Use double-sided adhesive bonding for components and mounting surfaces, e.g., 3M VHB 4991.
When mounted on curved surfaces, the component should not bend more than 20 degrees.
General| Brand | TopSolar |
|---|---|
| Model | SOLAR5005022 |
| Category | Solar panel |
| Language | English |
To Next Page