Firmware Version 3/4.31.37
Corrected Web RCU Ditto processing of the stop key.
7/19/11 WJP
Added Preset, Component and Additive product names to the alibi log.
7/19/11 WJP
Added new configuration W&M protection type of CONDITIONAL_DENSITY.
Added new configuration parameter "W&M Density Lock", that will conditionally
move default density, default relative density and API gravity parameters under W&M
protection.
7/26/11 MSH
For CN Builds, added truck_no, carrier_id, tds_retry_interval, seller_id,
consignee parameters. No register access.
For CN Builds, added comments, is_manual_bol, transaction_id and consignee to
transaction archive header. TDS access only. No register or print access.
7/28/11 WJP
Added Boot Screen and R000 extension to identify custom built firmware.
8/9/11 WJP
Corrected "ReprintTicket" prompt to only reprint ticket on Next key press, not
Enter key press.
8/23/11 WJP
Added clear of entire nvram DB blocks to avoid config problems when switching
between build types.
Added check for struct size exceeding block size.
Added start and end dates to transaction headers for use with TDS records.
Updated Transaction Archive database version.
Updated GPS, GPS_SITE_DATABASE and GPS_POSITION_LOG compiler switches.
8/24/11 WJP
Added TDS_INTERFACE precompiler switch for selective inclusion.
Updated support for CONFAR_BUILD and CN_BUILD precompiler switches.
Removed MULTILOAD_MOBILE_BUILD precompiler switch and logos.
Increased SOFTWARE_BUILD_ID size from 15 to 25 characters (R000 and boot screen
display).
For CONFAR_BUILDs, added LAT,LONG and WELL NAME to TDS transaction comments.
8/24/11 WJP
Bumped position log from 200 records to 500 records.
Increased GPS database block size from 512K to 1M.
Cleaned up GPS data on Idle Screen to allow for GPS_SITE_DATABASE and
GPS_POSITION_LOG at the same time.
8/24/11 WJP
Clean up RCU Setup Screen for selective inclusion of TDS_INTERFACE parameters.
8/26/11 WJP
Added automatic selection of Conoco Logo on CONFAR builds.
9/9/11 WJP
Correct display of Load Volume on the Main Preset Screen to display Hundredths if
Use_Hundredths is enabled.
Added printing of Average Load Temperature if the Load Totals are displayed
directly under the transaction details (tot_gpos=99 and tot_glin=99).
To Next Page
Loading...