PROGRAMMING THE THERMOSTAT
6
Set 5+1+1 Program Schedule
To customize your 5+1+1 program schedule, follow these steps
Weekday:
Saturday:
Select HEAT or COOL using the SYSTEM key.
Note: You have to program heat and cool each separately.
Press MENU
Press SET SCHED. Note: Monday-Friday is displayed and the WAKE icon is shown. You are now
programming the WAKE time period for the weekday setting.
Time is flashing. Use the or key to make your time selection for the weekday WAKE time
period. Note: If you want the fan to run continuously during this time period, select ON with the FAN key.
Press NEXT STEP
The setpoint temperature is flashing. Use the or key to make your setpoint selection for the
weekday WAKE period.
Press NEXT STEP
Repeat steps 4 through 7 for weekday LEAVE time period, for weekday RETURN time period, and for
weekday SLEEP time period.
Repeat steps 4 through 7 for
Saturday WAKE time period, for
Saturday LEAVE time period, for
Saturday RETURN time period, and
for Saturday SLEEP time period.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Sunday:
Repeat steps 4 through 7 for
Sunday WAKE time period, for
Sunday LEAVE time period, for
Sunday RETURN time period, and
for Sunday SLEEP time period.
10.
Additional step if R251W indoor remote sensor is connected.
The T955WH master thermostat will either average all sensors (system average) or only
use one sensor for the system ambient temperature (priority). The default setting is
SYSTEM AVERAGE, which means all sensors are averaged to create the system average
ambient temperature reading. The NEXT ZONE key can be pressed to change the priority.
The system information area of the display shows the priority.
For Example: There is an R251W connected and it is named REMOTE 1. If the NEXT
ZONE key is pressed until REMOTE 1 is shown, then the REMOTE 1 ambient temperature
reading will be used exclusively for that time period. All other sensors will be ignored.
To Next Page
Loading...
