TOPVERT G1/H1/P1 Series
E-24
Pr3-05
AI1 analog Input bias mode
0: Zero bias
0
1: Value lower than bias = bias
2: Value higher than bias = bias
3: The absolute value of the bias voltage while
serving as the center
Pr3-06
AI2 Analog Input (see Pr3-02)
Same as Pr3-02 0.00
Pr3-07
AI2 analog Input bias
0.00
～
20.00mA 4.00
Pr3-08
AI2 analog Input gain
-500.0
～
+500.0% 100.0
Pr3-09
AI2 analog Input bias mode
0
：
Zero bias
1
1: Value lower than bias = bias
2: Value higher than bias = bias
3: The absolute value of the bias voltage while
serving as the center
Pr3-10
Loss of the AI2 signal
0: Disabled
0
1: Continue operation by the last frequency command
2: Decelerate to stop
3: Coast to stop and display AcI.
Pr3-11
AI3 Analog Input (see Pr3-02)
(Same as Pr3-02)
0.00
Pr3-12
AI3 analog Input bias
-10.00
～
10.00V
0.00
Pr3-13
AI3 analog Input gain
-500.0
～
+500.0% 100
Pr3-14
AI3 analog Input bias mode
0: Zero bias
0
1: Value lower than bias = bias
2: Value higher than bias = bias
3: The absolute value of the bias voltage while
serving as the center
Pr3-15
Analog output 1 function (AO1)
0: Output frequency (Hz) 0
Pr3-16
Analog output 2 function (AO2)
1: Command frequency (Hz)
0
2: Motor Speed
3: Output current (A rms)
4: Output voltage (VAC)
5: DC BUS voltage (VDC)
6: Power factor
7: Power
8: AI1 (V)
9: AI2 (mA)
10: AI3 (V)
11~12: (Factory Resewrved)
13: Output voltage command
14: Counter Value
15: User defined value on Pr3-21
16~23: (Factory Reserved)
24: Define to digital output (MOx)
◎
◎◎
◎
Pr3-17
AO1 Analog output gain
-900.0
～
900.0% 100.0
Pr3-18
AO2 Analog output gain
-900.0
～
900.0% 80.0
Pr3-19
AO1 Analog output bias -10.00
～
10.00V 0.00
Pr3-20
AO2 Analog output bias 0.00
～
20.00mA 4.00
Pr3-21
User defined analog output
value
0.0
～
100.0% 0.0
Group 4: Multi-Step Speed and Process Logic Control operation parameters
Parame
ters
Functions Settings
Factory
Setting
User
Pr4-00
The 1st step speed of PLC Run or MSS Run
0.00
～
600.00 Hz
(H1:00.0
～
6000.0Hz)
0.00
Pr4-01
The 2nd step speed of PLC Run or MSS Run
0.00
～
600.00 Hz
(H1:00.0
～
6000.0Hz)
0.00
Pr4-02
The 3rd step speed of PLC Run or MSS Run
0.00
～
600.00 Hz
(H1:00.0
～
6000.0Hz)
0.00
To Next Page
Loading...