TOPVERT G1/H1/P1 Series
E-36
External Base Block
(bb) {40}
(one of Pr2-01~Pr2-06 or
Pr2-26~Pr2-28 =15 or 16 and
act)
When the external input terminal (B.B) is active, the
drive output will be turned off.
Deactivat
e the external input terminal (B.B) to operate
the drive again.
EEPROM of PU-02 failure
(1 CoPy)
Replace a PU-02
Nothing to save due to PU-
is empty (2 CoPy)
Make sure PU-02 had read data then try again
Cannot Save due to drive
model is not the same
(3 CoPy)
Recheck the drive models
Parameter error in PU-02
(4 CoPy)
Parameter is out of range, recheck the Parameter in
PU-02
Cannot Save due to drive is
running (7 CoPy)
Stop the drive then try again
Cannot Save or Read due to
drive was password locked
(8 CoPy)
Unlock the drive then try again
To Next Page
Loading...