TOPTEK TOPVERT L1 Series - Page 21

TOPVERT L1 Series
E- 20
28: Auxiliary Motor no. 2
29: Auxiliary Motor no. 3
30: Over-torque 2 (ot2) ◎
31: OH2 pre–warning indication ◎
32: Motor selection output (Pr5-49) ◎
33~47: (Factory Reserved)
48: Master speed executing
49: PLC Run step 1 executing
50: PLC Run step 2 executing
51: PLC Run step 3 executing
52: PLC Run step 4 executing
53: PLC Run step 5 executing
54: PLC Run step 6 executing
55: PLC Run step 7 executing
56: PLC Run step 8 executing
57: PLC Run step 9 executing
58: PLC Run step 10 executing
59: PLC Run step 11 executing
60: PLC Run step 12 executing
61: PLC Run step 13 executing
62: PLC Run step 14 executing
63: PLC Run step 15 executing
64~79: (Factory Reserved)
◎
◎◎
◎
Pr2-26 (Factory Reserved)
(Factory Reserved) 0
◎
◎◎
◎
Pr2-27
(Factory Reserved)
◎
◎◎
◎
Pr2-28
(Factory Reserved)
Group 3: Analog Input/Output parameters
Parame
ters
Functions Settings
Factory
Setting
User
Pr3-00
Addition Function of the Analog
Inputs
0: Enable addition function
0
1: Disable addition function
Pr3-01
Analog input noise filter time 0.00~2.00 sec
0.10
AI1 Analog Input
0: No functions
1
1: Frequency command
2: To adjust 1st Acceleration/deceleration time)
(same as Pr1-11, Pr1-12)
3: Over Current stall prevention level during
constant speed run on the constant torque
region (same as Pr5-12)
4: Over Current stall prevention level during accel
on the constant torque region (same as Pr5-10)
5: Over-Torque detection level 1 (ot1)
(same as Pr5-16)
6: Motor 1 Torque boost level (same as Pr5-01)
7: Auxiliary command when main frequency
command is AI1 only
8: (Factory Reserved)
9: (Factory Reserved)
10: Auxiliary command of master frequency
command
11: PID feedback signal
12: PID offset signal (same as Pr7-05)
13: DC Braking current level (same as Pr6-00)
14: Voltage adjusts during run. (AI1 Pr3-02 only)
15: External temperatures signal