TOPTEK TOPVERT L1 Series - Page 23

TOPVERT L1 Series
E- 22
Pr4-25
The 10th Step duration of PLC
Run or MSS Run
0.0～65500 Sec 0.0
Pr4-26
The 11th Step duration of PLC
Run or MSS Run
0.0～65500 Sec 0.0
Pr4-27
The 12th Step duration of PLC
Run or MSS Run
0.0～65500 Sec 0.0
Pr4-28
The 13th Step duration of PLC
Run or MSS Run
0.0～65500 Sec 0.0
Pr4-29
The 14th Step duration of PLC
Run or MSS Run
0.0～65500 Sec 0.0
Pr4-30
The 15th Step duration of PLC
Run or MSS Run
0.0～65500 Sec 0.0
Pr4-31
The PLC Run or MSS Run time
multiplier
1～10 1
Pr4-32
The PLC Run or MSS Run
operation direction of each step
00000~07FFF（0：forward；1：reverse） h00000
Pr4-33 PLC Run operation mode
Bit 0
(bxxxx0)
0: Direction determined by Pr4-32
b01000
1: Direction determined by the master
speed
Bit 1
(bxxx0x)
0: Without zero intervals (Continue
mode)
1: With zero intervals (Stop mode)
Bit 2
(bxx0xx)
0: Run zero speed when PLC Run
Paused
1: Run original programmed step
speed when PLC Run Paused
Bit 3
(bx0xxx)
0: Re-Execute PLC Run from step 0
after recover from power interruption
1: Continue Execute PLC Run from
the point which power interrupted after
recover from power interruption
Pr4-34 PLC Run operation cycle
0~60000 : 0~60000 cycle
0
0= PLC Run disabled
60001: Continuously execute recurring cycles
Pr4-35
What to do after PLC Run
completed
0~15：step speed (0=master speed)
16
16：stop
Pr4-36
Multi-Step Speed Run (MSS
RUN) operation mode
Bit 0
(bxxxx0)
0: Direction determined by Pr4-32
b00001
1: Direction determined by the master
speed
Bit 1
(bxxx0x)
0: Duration of MSS Run determined by
Mix terminals.
1: Duration of MSS Run determined by
Pr4-15~Pr4-30 setting.
Bit 2
(bxx0xx)
0: Without zero intervals (Continue
mode)
1: With zero intervals (Stop mode)
Bit 3
(bx0xxx)
0: PID offset ineffective
1: MSS Run + PID offset effective
Group 5: Motor parameters and protection parameters
Parame
ters
Functions Settings
Factory
Setting
User
★
Pr5-00
Full-Load Current of Motor 1 Amp (10~120% of drive’s rated current)
xxxA
（100%）
Pr5-01
Auto Torque Compensation of Motor
1
0.0～25.0% 0.0
Pr5-02
Slip Compensation of Motor 1
0～20 RPM 0
Pr5-03
Number of Motor Poles 1
2～20 4
Pr5-04 Rotor Resistance R1 of Motor 1 0.000～65.535 Ω 0