Topworx Valvetop DXP - User Manual

TM
Table of Contents
2 Switchbox Orientation
3 Mounting
3 Storage Conditions
4 DXP Dimensional Drawing
5 DXP - IIC Dimensional Drawing
6 DXS Dimensional Drawing
7 DXR Dimensional Drawing
8 Shaft Detail
9 Features & Specs
10 Installation
11 Calibration & Operation
12 Calibration & Operation
13 Maintenance
14 Pneumatic Hookup
15 Spool Valves & Pilots
16 Safe Use
17 Certifications & Approvals
18 Warranty
19 Notes
TM
Valvetop D-Series
with 4-20mA Transmitter & HART Protocol
Installation, Operation & Maintenance Manual

Summary

Installation on Actuator

Orientations, Normal and Reverse Acting

Mounting

Dimensions and Materials: Valvetop DXP

Dimensions and Materials: Valvetop DXP - Flameproof Ex d IIC

Dimensions and Materials: Valvetop DXS

Dimensions and Materials: Valvetop DXR

Features and Specifications

4-20 mA Position with HART Protocol

Overview of transmitter features, HART capabilities, and electrical specifications.

Operation of the 4-20 mA Current Position Transmitter

Calibrating End Set Points Locally

Provides step-by-step instructions for local calibration of the 4-20mA transmitter.

Calibration Flow Chart

LED Flash Code Diagram

LED Error Codes

Remote Calibration

Safe Use

Instructions for safe selection, installation, use, maintenance and repair

Provides guidelines for safe operation, installation, and maintenance of the equipment.

Special Conditions of Safe Use

Topworx Valvetop DXP Specifications

General

Category	Controller
Output Current	4-20 mA
Enclosure Rating	IP66
Housing Material	Aluminum
Protocol	HART
Communication Protocol	HART, Modbus
Operating Temperature	-40 to 85 °C