The head Of the HID bulb is made Of glass, please take care to
prevent breakage during installation and operation;
The head Of the HID bulb is an optical device. It is recommended
to wear gloves during the installation to avoid smearing the bulb
surface and affecting its optical effect;
After the bulb is installed correctly, there will still be a certain space
for turning. NO need to worry about it, its normal;
Please don't look directly at the HID bulb turned on to prevent your
eyes from being hurt by the light;
Due to the limited operating space Of some models, you may need
to remove the assembly or remove some equipment;
There are a positive and a negative on the plug, please note the
direction during installation.
3
INSTALLATION STEPS
1. Models: Dl S/D3S/D8S
O YouTubeI HIDD3SHEADLIGHTBULBINSTALLATION O
Step 1: Park the vehicle and make sure the headlights are tumed off for
more than half an hour, in case you get burned;
Step 2: Open the hood, locate the bulb that needs to be replaced, and
remove the dust Cover (the ballast and the back cover are one piece for
most vehicle models), which you may need to rotate or pull Out;
Step 3: Locate the HID bulb, and Step 4: Unplug it;
tum counterclockwise or loosen
the spring to remove the bulb;
4
To Next Page
Loading...