PRODUCT PARAMETERS
Voltage
Color Temp
Ambient Temp
DIS/D2S:85V D3S/D4S:45V
4500K/6000K/8000K
-40 c-120C
35W
FAQ
1. Q: Fail to match with your car?
A: You may buy the wrong bulb model, please check and replace it.
2. Q: Fail to switch on after installation or switch Off automatically in
few minutes after on?
A: It may be caused by the mismatch between the bulb and ballast.
The output characteristics Of ballast may vary for different vehicle
models, so there will be a certain probability that the voltage
output waveform is unmatched, causing the bulb cant be
switched on normally.
7
3. Q: Fail to switch both headlights on?
A: Maybe one bulb is not installed properly, please check it, and
then try to switch the left and right bulb for a further test.
4. Q: Poor Light Pattern?
A: Maybe the bulb is not installed in place, causing the light point to
not be in focus, reinstall it
5. Q: The plug is wrong connected?
A: There are a positive and a negative on the plug, please make
sure which side is positive, which is negative. If the PIN is
deformed, correct it with a tool and reinstall it.
CUSTOMER SERVICE TEAM
support@torchbeam.com
If you have any questions,please contact our customer service team
Made In China
8
To Previous Page
Loading...