Tornado 99690 BD 22/ - User Manual

Questions and Answers

C
Colleen RichardsonAug 11, 2025
What to do if the squeegee on my Tornado Floor Machine does not dry properly?
- W
  wallmichaelAug 12, 2025
  If the squeegee on your Tornado Floor Machine isn't drying properly, start by ensuring the squeegee rubbers are clean. Also, check the height and inclination of the squeegee. Make sure the suction hose is correctly inserted into the recovery tank and clean the suction filter. Replace the rubbers if they are worn out, and confirm that the vacuum motor switch is turned on.
A
Abigail BarronAug 17, 2025
Why is my Tornado 99690 BD 22/ not cleaning properly?
- S
  Shawn EverettAug 17, 2025
  If your Tornado Floor Machine isn't cleaning effectively, the brushes might be the issue. If the brushes have worn bristles (less than .6 inches), replace them. Also ensure that you are opening the solution valve enough to provide sufficient detergent and that the liquid detergent is in the recommended percentage. You may need to increase the brush base pressure.
K
Kathleen LeeAug 25, 2025
How to troubleshoot vacuum motor not working on Tornado 99690 BD 22/?
- F
  Francisco KellyAug 25, 2025
  If the vacuum motor on your Tornado Floor Machine isn't working, first, check that the key switch is in the correct position. Then, verify the charge level of the batteries and ensure the battery connector is properly plugged in. Confirm that the switch is on and that the red connector of the vacuum motor is correctly plugged in.
E
Eric GillAug 30, 2025
Why is my Tornado 99690 BD 22/ Floor Machine producing excessive foam?
- G
  Gina OdomAug 30, 2025
  To address excessive foam production in your Tornado Floor Machine, verify that you are using a low foam detergent. If the problem persists, add small quantities of anti foam liquid into the recovery tank. Be aware that a bigger quantity of foam is produced when the floor is not very dirty, so dilute the detergent solution in this case.
D
damon49Sep 5, 2025
What to do if there is insufficient water on the brushes of my Tornado Floor Machine?
- J
  Joshua AllisonSep 5, 2025
  If there's insufficient water on the brushes of your Tornado Floor Machine, first check that the solution valve lever is open. Next, check the level of the liquid in the solution tank. Also, ensure that the solution filter is clean. Since the machine is equipped with a solenoid valve, rotate the drive control levers.