5
FOR COMMERCIAL USE
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic precautions should always be followed including the following:
READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE
WARNING To reduce the risk of fire, electric shock or injury:
Unplug machine when not in use. If handle switch lever is activated accidentally, high starting torque will cause machine
to move and may cause damage or injury.
Unplug machine before:
z Leaving machine unattended
z Changing pads
z Attempting any maintenance or adjustment
This equipment is equipped with a three-conductor cable and three-prong grounding type plug to fit a grounding type
receptacle. Do not break off or pull out the grounding prong on plug. Adapters are available for connecting three-prong
grounding wire or terminal extending from the adapter must be connected to a permanent ground such as to a properly
grounded electrical outlet box. If cord becomes frayed or damaged in any manner, replace. Otherwise possible electric
shock may result.
Do not put hands under base - rotating parts could cause injury. Always keep hands feet and loose fitting clothing away
from moving parts to prevent possible injuries. Use care to keep electrical supply callable from contacting moving parts,
such as floor brushes or pads.
To avoid electrical shock, use indoors only. Do not use machine in areas where flammable and/or explosive vapors or
dust are present.
Make sure voltage and frequency at the wall receptacle correspond with that indicated on name plate before plugging in
machine. A 20 amp circuit is recommended. Right or left switch levers will independently operate the motor.
Never use a device to lock the switch lever in the “ON” position.
Use only a 12 Ga. three-wire extension cable which have 3-prong grounding type plugs and 3-prong receptacles that
accept the machine’s plug.
Always operate this machine with all of the cable removed from the handle. Failure to do so will upset the precision
balance of the machine.
Do not add weight to this machine - this will upset the balance and may cause motor overload.
Pad holders and brushes must be properly maintained to insure maximum cleaning results.
z To avoid electrical shock do not expose to rain; store indoors.
z To avoid fire do not use with a flammable or combustible liquid to clean a floor.
z Risk of explosion. Floor sanding can result in explosive mixture of fine dust and air. Use this machine
only in a well ventilated area, free from any flame or match.
z Do not add weight.
z Do not hop the brush or pad holder onto the machine.
z Disconnect before servicing.
z Do not store with brush, pad holder or pad on floor.
z Refer to this manual for additional instructions.
SAVE THESE INSTRUCTIONS
https://harrissupplyind.com - To Order Parts Call 608-268-8080
To Next Page
Loading...